HP SIM and blade enclosures

[Chris254]

I have installed HP SIM 5.2 with Update 2 to monitor my blades.

I have added all the blades manually and they are being monitored
fine. However, two "P-class enclosures" have been detected by HP SIM - I don't know what
they are - I think they are the two servers sitting on top of the blades and
probably are connected to them as well.

I can see some of the blades coming under the tree of these enclosures and
sometimes they disappear. I also don't get a lot of information about the
enclosures as well - for example, for one of the enclosures HP SIM says:

Firmware Revision Not Available
Power Zone Not Available
Unit ID (LED) Not Available

My question is: how can I add all the blades under these enclosures and how
can I get proper information about these enclosures?

Thanks for any suggestion.

[marsh_1]

hi,

have you got the bladecentre plug-in ? see here :-

http://h18013.www1.hp.com/products/servers/management/bsme/index.html

HTH