Server Management - Systems Insight Manager
1833875 Members
1818 Online
110063 Solutions
New Discussion

Re: HPSIM 4.1 Version Control Agent status "?"

 
Richard Layton
Frequent Advisor

HPSIM 4.1 Version Control Agent status "?"

Hello,

For some reason I only one of my server has the green check mark in the SW colume in the All Systems view. I checked the other systems and when I click on the blue ? I get the same info and I do with the one with the green check mark. I verified the config for the agents and they are all the same, yet only one shows the green check. Anyone know why this is?

Thanks
3 REPLIES 3
Craig McKellar
Frequent Advisor

Re: HPSIM 4.1 Version Control Agent status "?"

Holding the cursor over the "?" should give you the reason why it's not fully configured - most likely a security trust issue? I would check the Trusted certificates (if you're using them) under Device Home\Settings\Options, and also try re-configuring the VC agent settings to point to the VC Repository Manager. Then try a software poll.
Richard Layton
Frequent Advisor

Re: HPSIM 4.1 Version Control Agent status "?"

Is there a way to reconfigure the VC without reinstalling? I don't know the passwords on the old installs so I have been having to reinstall the whole support paq and it takes forever.
Craig McKellar
Frequent Advisor

Re: HPSIM 4.1 Version Control Agent status "?"

You could run \\CIM\\repository\setup.exe which will allow you to configure the VCA required with a new password and push it out to the server in question?