HPE Community
Server Management - Systems Insight Manager
1846663 Members
4397 Online
110256 Solutions
New Discussion

HPSIM and IBM Blades

 
Peter_374
Occasional Contributor

‎02-16-2005 01:42 PM

‎02-16-2005 01:42 PM

HPSIM and IBM Blades

Hi,
We have installed IBM Blades and I was hoping to monitor them in HPSIM, is this possible?, do HP use cross-platform MIBs or do I simply configure SNMP on the IBM Blade to point to our Management box? Is there any way to do this?

Thanks in advance :-)
Peter
0 Kudos
Reply
1 REPLY 1
Peter Stringer
Regular Advisor

‎02-21-2005 02:32 AM

‎02-21-2005 02:32 AM

Re: HPSIM and IBM Blades

We have same senario.

make sure snmp is installed and director client.

After a discovery cycle you will see and entry for your blade/s.

If you select this and select links you should see a link to director ( normally http://servername:411) which will enable you to manage blade.

regards

Pete
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.