Initial Proliant Support Pack Install

[Martin C. Wells]

When trying to install the Initial Proliant Support Pack, I am getting the following error.

"Could not execute the tool: Initial Proliant Support Pack Install. No value was supplied for required argument with prompt: Enter drive letter for setupc.exe (i.e. E:"

I've looked around to see where I need to specify this value but can't find it. Thanks in advance, any help would be appreciated.

Martin

[Rob Buxton]

Setupc is the command line variant. There should eb a setup.exe in the Softpaq. Run that and it brings up the Remote Deployment Utility.

Using that you can first configure the components, password, trust mechanism etc.
And then deploy the entire softpaq to the machine you're on, or a target machine if desired.