HPE Community
Server Management - Systems Insight Manager
1838615 Members
2484 Online
110128 Solutions
New Discussion

Proper configuration for alarms?

 
Michael Day
Advisor

‎06-08-2005 04:44 AM

‎06-08-2005 04:44 AM

Proper configuration for alarms?

My HP SIM is not letting me know when there are critical hardware condidtions such as a drive going down. What are the prerequisites for a client to comunicate to HP SIM that there is a hardware condition that requires attention? It seems for the most part the only alarms i get are when a server is up or down ... that is all.

I noticed a drive was red on a server but had not recieved any alarm. So I replaced the drive and upgraded the drivers to 7.30a. I have 200 clients and their PSP versions are anywhere from 5.3 to 7.3. I upgraded my test box to 7.3 ... pulled a drive from its RAID array and never recived an alarm!
0 Kudos
Reply
1 REPLY 1
Michael Day
Advisor

‎06-08-2005 07:07 AM

‎06-08-2005 07:07 AM

Re: Proper configuration for alarms?

And I was not recieving the event because I was not installing the PSP's properly. I was not selecting the box â allow to overwrite newer versions of the driversâ ?. I seem to have the Microsoft SCSI drivers installed on some boxes (have no idea why except maybe during serice pack installs but I thought for sure i didn't overwrite any compaq dri
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.