HPE Community
Server Management - Systems Insight Manager
1833845 Members
2345 Online
110063 Solutions
New Discussion

Re: RILO II and Systems Insight Manager

 
Sean Gamble
Occasional Contributor

‎07-09-2004 06:45 AM

‎07-09-2004 06:45 AM

RILO II and Systems Insight Manager

How do I get my RILO II boards to associate with my servers? I have 2 that it discovered and it says x.x.x.x in server xxx but under the actual server the MP has a ? I have other servers where I had to manually add the IP of the RILO II board before it found it but it just shows up as a RILO II board and is not associated with a server.
0 Kudos
Reply
1 REPLY 1
Rob Buxton
Honored Contributor

‎07-11-2004 12:38 PM

‎07-11-2004 12:38 PM

Re: RILO II and Systems Insight Manager

I'm seeing this on a W2003 Server, not too sure why yet. Is yours a W2003 Server?

But, go to the HP Management Agent GUI via control panel on the Server.
Check that the Remote Insight Information is listed in the Active Agents, if not add and restart the Agents.
Then you might need to rerun the Device Discovery. This should make it visible to IM.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.