HPE GreenLake Administration
- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- Server Management - Systems Insight Manager
- >
- RILO II and Systems Insight Manager
Server Management - Systems Insight Manager
1833832
Members
2987
Online
110063
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2004 06:45 AM
07-09-2004 06:45 AM
RILO II and Systems Insight Manager
How do I get my RILO II boards to associate with my servers? I have 2 that it discovered and it says x.x.x.x in server xxx but under the actual server the MP has a ? I have other servers where I had to manually add the IP of the RILO II board before it found it but it just shows up as a RILO II board and is not associated with a server.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-11-2004 12:38 PM
07-11-2004 12:38 PM
Re: RILO II and Systems Insight Manager
I'm seeing this on a W2003 Server, not too sure why yet. Is yours a W2003 Server?
But, go to the HP Management Agent GUI via control panel on the Server.
Check that the Remote Insight Information is listed in the Active Agents, if not add and restart the Agents.
Then you might need to rerun the Device Discovery. This should make it visible to IM.
But, go to the HP Management Agent GUI via control panel on the Server.
Check that the Remote Insight Information is listed in the Active Agents, if not add and restart the Agents.
Then you might need to rerun the Device Discovery. This should make it visible to IM.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
Company
Events and news
Customer resources
© Copyright 2025 Hewlett Packard Enterprise Development LP