server shown but not sending System is unreachable

[_bj]

i can see the server in "all servers"

but if i restart the server i dont get a Critical error..
where to begain locking for errors ?

[ramesh_naik_]

Hi Bj,

Try this to monitor the critical changes:
1. Select Optionsâ Eventsâ Status Change Event Settings. The Status Change Event Settings
page appears.

2. Two options are available on this page. Select one or both of the options.
â ¢ Enable creation of system status change events.
This option causes a system unreachable event to be sent whenever a system cannot be reached by a ping through the Hardware Status Polling task.Enabling this option causes a system reachable event to be created whenever the system is reachable again.
â ¢ Automatically clear unreachable system status change events when system is reachable.
If this option is enabled, when a system that was previously unreachable starts to respond, the previous unreachable event is marked with a cleared state.

3. Click OK to apply changes.

Hope this works!!!!

Regards,
rmn