HPE Community
Server Management - Systems Insight Manager
1833187 Members
2758 Online
110051 Solutions
New Discussion

Re: show specific drive failure in EVA

 
nameless_girl
Advisor

‎05-05-2011 12:15 PM

‎05-05-2011 12:15 PM

show specific drive failure in EVA

Hi!

I have HP SIM 6.3 monitoring 3 EVA systems via a CommandView server. HP SIM detects when a drive fails and sends me the appropriate alerts ( Storage Cell Event) -- but it does not tell me specifically which drive failed. I still have to log in to CVEVA and click through the tree to figure out which disk failed, or do a physical inspection. Is there a way to make HPSIM tell me specifically which drive failed?
0 Kudos
Reply
2 REPLIES 2
shocko
Honored Contributor

‎05-05-2011 11:59 PM

‎05-05-2011 11:59 PM

Re: show specific drive failure in EVA

What version of EVA? Have you discovered the SAN managament applicance connected to it fully? Can you post the results of discovery? You may need to set credentials in SIM to connect to the SMI-S agent on you SMA
If my post was helpful please award me Kudos! or Points :)
0 Kudos
Reply
David Claypool
Honored Contributor

‎05-06-2011 05:24 AM

‎05-06-2011 05:24 AM

Re: show specific drive failure in EVA

@shocko, she's getting alerts so all of that is working.

@nameless_girl, HP SIM is just passing along the information as CV gives it.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.