SIM HW/MP/SW Status Yellow / Minor

[Gerber Dumeng]

Hi, i have some Server (and its ilo) im my Sim with the Hardware/Management Processor/Software Status Yellow/Miner. But on the Server, everything is ok and green. I tried to remove and redescover the server, but they are still yellow... any idea?
Thanks Dumeng

[Mike_604]

Hi Gerber,

I am having the same problem on an old 570G1 server. I hope someone can shed some light.

Thanx Mike

[Guy P. Perkins]

have you checked to make sure that your snmp agents are set up correctly?

[Neal Bowman]

Are there any entries in the Integrated Management Log? Entries that have not been marked as Repaired will cause this, even though the main system status is showing Green.

If software status is yellow, there may be an updated firmware/PSP component that is showing out of date or has a newer version available.

Hope this helps,
Neal

[Gerber Dumeng]

I found the problem, it was the selftest of riloe II board (SMH¦Management Processor¦Remote Insight¦Self Test Results¦NVRAM Write/Read/Verify). This one was red... after reseting the riloe, it was green again. But the question is still why is the server yellow in the sim and green on the smh, shuldnt it show the problem on the smh?

[Neal Bowman]

Gerber,
You should see it turn green after the next hardware polling cycle. If not, there may still be something in the IML that has not been cleared or marked as repaired.

[Guy P. Perkins]

again, have you looked at your SNMP settings? SIM needs one Community String that requires Read / Create.

[Darren Z]

"But the question is still why is the server yellow in the sim and green on the smh, shuldnt it show the problem on the smh?"

The problem is that its a bug. I had the exact same issue on 300 servers (http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1047509).