System Management Homepage admin/password on Netware

[Bryan Snyder]

I have all my Windows servers configured, but I have been unable to determine how to set the administrator password for the System Management Homepage on my Novell Servers. The servers have never had the web agent installed until I recently installed Support Pack 7.00a and have now decided to use the web agent. I used CPQDPLOY to install and didn't see where I could configure the password prior. Any assistance would be appreciated. Thanks

[Jean-Christophe Valiere]

Normally after the installation of PSP you should 'configure' or 'activate' the service. It will ask you some question for the configuration.
If you are just looking for the authentification password, the command is hpwebsetup I believe.
But as I have never installed the soft on netware, I'm not sure it will help you.
But I hope ;)

[Bryan Snyder]

Now I'm really confused? I can't even find HPWEBSETUP anywhere in the NSSD S/W and never had to use it on my NT servers?

[Jean-Christophe Valiere]

Sorry, I didn't see 'Novell System' in your previous post and was believing you were under linux.
Nevertheless, for novelle system the default password is normally the login (ie administrator for administrator ...).
For more information you can look at the documentation at :
ftp://ftp.compaq.com/pub/products/servers/management/imaug.pdf
I hope it could help you.