VCA shows hardware that isn't there

[Andrew_346]

I've searched and can't find a single thread about this:

VCA on one server (DL385 G1, Win2K3x64) shows two items that are not installed on the server and continue to put VCA in a warning status:

-HP ProLiant Smart Array SAS/SATA Controller Driver for Windows Server 2003 x64 Edition
-HP ProLiant 64-Bit/133-MHz Single/Dual Channel Ultra320 SCSI HBA and SCxxXe series SCSI HBA Driver for Windows Server 2003 x64 Editions

Neither of which are installed on this server.

Another server, which I've removed from production and is a development server now, still reports the iLo with out of date firmware & driver, even though I've removed the iLo from that system.

How can I clean up these two VCA agents?

Thanks,
AJ

[Rob Buxton · Accepted solution]

See this thread:
https://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1127033

[Andrew_346]

Correction: RiLoe - card based was removed.

This particular server is an older ML530, no onboard iLo.

[Rob Buxton]

Just on the ILO, as it's integrated onto the board you cannot remove it.
You can remove the sub-agent from reporting the HA but not from the VCA.

From Control Panel, find the HP Management Agents GUI and then remove the Remote Insight Agents. This stops the reporting in the hardware.