Abilitare PCIe M2 su DL380Gen 10

[treingenia]

Hi,
I have a DL380Gen with SmartArray P408i. The server is in "UEFI Mode". But I can't find it in the built-in S100 controller and as a result I can't see while booting the M2 memory installed in the 13 PCIe slot, where I would like to install hypervisor. Can you help me?
Thank you
D.

[BPSingh]

Greetings!

1. Please verify "Smart Array SW RAID Support" is set from UEFI System Utilities (F9 option on POST). If not enabled, please enable RAID Support, save the settings, reboot fot the changes to take place.

Instructions on page 97

https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00016407en_us

2. After reboot, go to UEFI System Utilities again and follow steps mentioned under "Configure arrays" page 30 and configured logical drives on the M.2 drives listed under S100i.

https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00016407en_us

Note: You can also configure logical drives (Step 2 above) in Smart Array Administrator listed inside Intelligent Provisioning (F10 option on POST).