HPE Community
Servers - General
1825762 Members
1996 Online
109687 Solutions
New Discussion

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

 
Raphael_George
Occasional Contributor

‎09-01-2021 01:47 AM - last edited on ‎09-07-2021 06:21 PM by

‎09-01-2021 01:47 AM - last edited on ‎09-07-2021 06:21 PM by

HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

Hello everyone. I'm trying to install a 4th HDD in my ML30 Gen 10 server. But so far I can only see three. I see a single power cable running from the powerpack with four plug-in points into the hard drives. And I plugged them all successfully including the Four SATA cables too. Yet only three hard drives are coming up
0 Kudos
Reply
2 REPLIES 2
Ihaqueit
Trusted Contributor

‎09-01-2021 08:27 AM

‎09-01-2021 08:27 AM

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

Any raid configured?

I Haq
Reply
sudhirsingh
HPE Pro

‎09-06-2021 05:29 PM

‎09-06-2021 05:29 PM

Re: HP PROLIANT ML30 HARD DRIVES NOT RECOGNIZED

@Raphael_George

Power off the server and reset the SAS Cable and Hard Disk Drive power cable (cable SATA 4 In 1 kit)

If does not work, try to swap drive with other bay and isolate.

Regards,

Sudhir



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.