HPE DL360 Network Adapter not Working

[aelsharif]

Hi

I prepare a new hpe dl360 G10 server, I installed windows server 2019 and want to connect server to the internet, Unforchantily I couldn't .. Neither The adapter wont connected to the internet or the cisco SG200-26P, it gaves me (Generic USB-EEM Network Adapter)

I'm tring to install the driver for it, I could not figure which driver for it.

Any help please

Abdulsalam

[Torsten.]

USB?

This sounds like the internal connection to the ILO - a virtual interface new in Gen10.

Check in ILO settings if this virtual interface is enabled and try to set up another NIC.

[aelsharif]

How can I check iLO setting ? Fron where ?

[Torsten.]

From the ILO webpage.

Connect a cable to the ILO NIC, it will get a DHCP address.

You'll find the credentials on the pullout tab in front of the server.

[aelsharif]

Ok .. I disabled it and now I got only two adapther:

1. Embedded FlexibleLOM 1 Port 1
2. Embedded FlexibleLOM 1 Port 2.

Where is the ethernet adapter ? Do I miss the drivers?

I check the device manager and, Please take a lock of  photo .Network Adapter 
 

[Torsten.]

These are your 2x 10Gbit/s Ethernet adapters.

[aelsharif]

@Torsten. I have only this adapter, should I install ethernet adapter to my server? There is no other ports!