HPE Single Phase 1GB UPS Network Management Module factory reset

[HPE-GIL]

Hi,

After a change of IP address, my card is no longer accessible. I accessed it by the default IP 192.168.1.2 and I could clearly see the web interface. The default settings do not return after a cold reset (pressing the reset button for 15 seconds) and it is impossible to access them via another port (Putty on COM or via APIPA), how do I reset my card ? And how to change the IP address so that it can be accessed after a reboot since it didn't work when I changed it ?

Thanks if you can help...

[HPE-GIL]

Thank you for your answer,

Unfortunately I have already tried to switch to hyperterminal mode with Putty, the console opens but does not display anything and does not accept commands. I think my network card is dead because with another card I had no problem setting it up. However, the LAN interface leds light up and the control led is green.

[Parker12154]

Moved: 

HPE Single Phase 1GB UPS Network Management Module factory reset

Moved: https://community.hpe.com/t5/Servers-General/HPE-Single-Phase-1GB-UPS-Network-Management-Module-factory-reset/m-p/7173400#U7173400

Moved to Server-General Board