HPE Community
Servers - General
1851683 Members
3172 Online
104061 Solutions
New Discussion

Installing Heatsink in DL380 Gen 10 - Use Thermal Grease?

 
gghiq
Occasional Visitor

‎01-15-2021 02:42 AM

‎01-15-2021 02:42 AM

Installing Heatsink in DL380 Gen 10 - Use Thermal Grease?

Hello all,

I am trying to figure out how to install a standard heat sink correctly into a DL 380 Gen 10. The HPE ProLiant DL380 Gen10 Server User Guide on page 152 under the topic "Installing a 1U or high performance heatsink " describes how to remove thermal grease! the next topic "installing a processor" just talks about lowering and fixing the heatsink but does not mention thermal grease - confusing I find!

thanks for clarification

Georg

0 Kudos
Reply
2 REPLIES 2
StorageMike
HPE Pro

‎01-15-2021 05:54 AM

‎01-15-2021 05:54 AM

Re: Installing Heatsink in DL380 Gen 10 - Use Thermal Grease?

Hi

IIRC the heatsink should have the required thermal compond already on it.

Thanks

I work for HPE

Accept or Kudo

0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎01-15-2021 09:23 AM

‎01-15-2021 09:23 AM

Re: Installing Heatsink in DL380 Gen 10 - Use Thermal Grease?

You need to appy it of course!

 

By the way, customers should not install CPU and heatsink, unless they have the special torque driver!


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.