HPE Community
Servers - General
1855680 Members
2472 Online
104103 Solutions
New Discussion

Non-HP UPS connected to A180C by RJ48 MUX

 
Kamrowski
Occasional Contributor

‎09-27-2004 06:32 PM - last edited on ‎02-04-2014 12:06 AM by

‎09-27-2004 06:32 PM - last edited on ‎02-04-2014 12:06 AM by

Non-HP UPS connected to A180C by RJ48 MUX

Has anybody connected succesfully some modern UPS via RS232C (RJ48 MUX).
I prepared correct logical cable ( I think so) but UPS proper daemon doesn't see UPS.
Pinouts of cable:
RJ48 (MUX) UPS (DB9)
6 --> 3 Tx
4 <-- 2 Rx
7 ground 5

Viewing traffic on /dev/tty1a1 port I noticed
only transmition data, no data was receiving.

 

 

P.S. This thread has been moevd from Storage > General to Servers > general. - Hp Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.