ProLiant ML 110 Server not detecting the SSD hard Drive under intelligent provisioning?

[nisharvp]

I have ML 110 Server and i wanted to upgrade the same with new SSD. I purchased HP reccomomnded ssd drives ( Kingston DC600 2.5" SATA REV 3.0 960 GB. But when i do the intelligent provisioning, it is not detecting the Hard Drives. Can anyone help me to sortout the issue.

[shiva_jr]

Hi nisharvp,
      For the HPE servers, Only HPE options parts are tested on the HPE Server products.   Not sure about compatibility of the third party disk drives. Please refer this quickspecs (Page no. 25) for the drives that are supported on ML110 Gen10 server.

If the drive is supported, please refer the following suggestions-
1) Update the system firmware to the latest version. It will update the IP as well.
2) Check the controller mode is HBA/RAID, please configure it to RAID mode.
3) Be sure that the drive is cabled properly.
4) Ensure the Drive LED indicator are normal.
5)  As per my knowledge, Intelligent Provisioning cannot detect SR 100i Controller. Please verify the controller. Refer this link for driver.
6) Software RAID may be disabled. Please refer this link to enable.
7) Even the issue persists, Please reply with Disk part no, RAID Controller installed, Server model, Error if any.

Regards,
Shiva_JR
Please mark as 'Accepted solution' if my post worked and award the 'Kudos'.