HPE Community
StoreEasy Storage
1827289 Members
3305 Online
109717 Solutions
New Discussion

Unable to access the NAS using NFS

 
CA1056576
Occasional Contributor

‎05-09-2004 06:56 AM

‎05-09-2004 06:56 AM

Unable to access the NAS using NFS

I am unable to connect a UNIX Server to the B3000 via NFS. Get a Server Not responding message from the UNIX serve, but I can connect to another server via NFS without any problems. Any body have any ideas what the problem is? I am thinking of uninstalling the OEM version of SFU, and installing 3.5 to see if that helps.

Don Jones
0 Kudos
Reply
2 REPLIES 2
CA1118839
Valued Contributor

‎05-10-2004 10:03 AM

‎05-10-2004 10:03 AM

Re: Unable to access the NAS using NFS

Assuming you have the folder configured for nfs sharing (either via NAS webUI or NFS Sharing tab under Properties on the folder) .. ensure the NFS service is started and Startup Type is set to "Automatic". You can stop and start the nfs service at command prompt, type:
net stop nfssvc
net start nfssvc
0 Kudos
Reply
CA1056576
Occasional Contributor

‎05-11-2004 08:14 AM

‎05-11-2004 08:14 AM

Re: Unable to access the NAS using NFS

Thanks for the reply, but the service has been stopped and restarted several times. NFS sharing is enabled, and right now is open to everyone, but still no luck mounting the share.

Don Jones
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.