HPE Community
Switches, Hubs, and Modems
1825747 Members
2460 Online
109687 Solutions
New Discussion

Accessing a stack commander without an IP?

 
Preston Gallwas
Valued Contributor

‎10-14-2005 06:14 AM

‎10-14-2005 06:14 AM

Accessing a stack commander without an IP?

Scenario: I wanted to swap the IP address for managmenet from VLAN1 to VLAN2.

Untagged 1-26 to VLAN2 (2626B / 8.60 firmware)
Lost comm

It still appears to work, however, the commander shows down from the member switches

Is there a way to use the members to conncet to the stack commander?

yikes :) i dont want to drive out there!
0 Kudos
3 REPLIES 3
Manfred Arndt
Valued Contributor

‎10-14-2005 12:48 PM

‎10-14-2005 12:48 PM

Re: Accessing a stack commander without an IP?

Ooops...you could try and get someone at the site to connect via the serial port and walk them through the configuration.
0 Kudos
Regnar Bang Lyngsø_2
Frequent Advisor

‎10-15-2005 09:19 PM

‎10-15-2005 09:19 PM

Re: Accessing a stack commander without an IP?

Some days you really miss the Cisco IOS delayed reload.
0 Kudos
Preston Gallwas
Valued Contributor

‎10-17-2005 03:03 AM

‎10-17-2005 03:03 AM

Re: Accessing a stack commander without an IP?

...no one out there can console in (teachers dont have those cables here hehe)
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.