Clearing loop-protection counteres

[Eikefjord]

I'm wondering it there is an command that can clear the counter for loop-protection view.

As you can see, port 36 is still reporting that it has detected loop....but this is not the case.

So how can I reset the counters??

Port Protection  Detected  Count      Since Last Loop  Action       Status
---- ----------- --------- ---------- ---------------- ------------ --------

5    Yes         Yes       149        9d,13h,55m,31s   send-disable Down

36   Yes         Yes       164        155d,20h,16m,34s send-disable Up

[LucianoCarvalho · Accepted solution]

Hello,

Maybe  disabling/enabling loop-protection on the port will clear the counters for that port.

regards.

[Eikefjord]

thanks, didn't think of doing that :-)

[FMaster007]

Hi there! What command is that? I have a port that was re-enabled from a loop but still showing loop detected and time since the last loop. 

[FMaster007]

Hi there! What command is that? I have a port that was re-enabled from a loop but still showing loop detected and time since the last loop.