HP Procurve J9087A crashes when attaching an APC AP7921 to the network

[Raymon van der Meijden]

Today i recieved two APC AP7921 PDU`s for colocation. When i connect one of these PDU`s to the network of my Procurve (J9087A) 2610-24-PWR the switch crashes and reboots.

The APC PDU`s are connect to port 3 using a basis 8 ports switch. This switch is always used to configure and install new devices. And is working fine with everything else.

The switch is configures with 3 vlan`s and DHCP snooping is active

dhcp-snooping
no dhcp-snooping option 82
dhcp-snooping vlan 12 14-15
power pre-std-detect

Switch Firmware:
Image stamp: /sw/code/build/nemo(ndx)
Oct 22 2008 16:11:27
R.11.22
193
Boot Image: Primary

[Roar Pettersen_1]

Advise you to upgrade to version R.11.30
and try again.

[Raymon van der Meijden]

I already upgrade tot version 11.30. And the switch now doesn`t reboot when connection the APC Masterswitch to the network.

Im testing this week if the new version introduces new problems on the network.