HP ProCurve Routing Switch - STP+VRRPe

[Vlad_3]

This circuit correct? Please, look attached. Does not work. From routers a storm of messages " dublicate MAC-address ".
Help...
Vlad

[Markku Leinio]

The second router has the same IP address in the third VLAN interface and in the VRRP virtual interface (x.x.3.3).

Just a typo in the figure?

[Vlad_3]

Ooops..Yes, a typing error.
router#2
int ve 3
ip add x.x.3.2

Version 07.6.04cT53
Boot Version 07.06.02

[Ralph Bean_2]

Hello Vlad -

Is the duplicate MAC address the XRRP Switches' virtual MAC address (see ftp://ftp.hp.com/pub/networking/software/59903016-e7.pdf, page 17-4)? What is the frequency of the duplicate MAC address warnings?

Regards,
Ralph

[Vlad_3]

Is the duplicate MAC address the VRRP-E virtual MAC address. The frequency of the duplicate MAC address - continuously.

2003-12-08 08:47:38 User.Warning 192.168.15.2 ZURS, Duplicate IP address 192.168.231.3 detected sent from MAC address 02e0.5224.17e7 interface 1/1, 1 packets
2003-12-08 08:47:38 User.Warning 192.168.15.2 ZURS, Duplicate IP address 192.168.241.3 detected sent from MAC address 02e0.5296.17f1 interface 1/1, 1 packets
2003-12-08 08:47:38 User.Warning 192.168.15.2 ZURS, Duplicate IP address 192.168.242.3 detected sent from MAC address 02e0.52bb.17f2 interface 1/1, 1 packets...

Thank you
Vlad

[Vlad_3]

At installation (initialization) of the module (24 Port 100TX Switch Module) in the chassis ports with 1 on 16 shine only (with 17 on 24 - do not shine).
With firmware 07.6.01bT53 this module works. With firmware 07.6.04cT53 this module does not works.
There can be a problem in this module?

Thank you
Vlad