HPE Community
Switches, Hubs, and Modems
1826408 Members
4062 Online
109692 Solutions
New Discussion

multinettin

 
ammadeyy
Contributor

‎12-02-2005 08:31 AM

‎12-02-2005 08:31 AM

multinettin

VLAN 2
10.10.1.1
10.10.2.1

10.10.1.1 can access to port 25 and 26 only
10.10.2.1 can access to all ports

how can i do that
0 Kudos
2 REPLIES 2
Hugo Tigre
Trusted Contributor

‎12-05-2005 02:54 AM

‎12-05-2005 02:54 AM

Re: multinettin

hi

if you have the external router (cisco) doing the routing than u can control almost everything in the router, so u can block or allow anything u want in the router. Use ACLs in the router.

regards, hugo
0 Kudos
Preston Gallwas
Valued Contributor

‎12-06-2005 04:49 AM

‎12-06-2005 04:49 AM

Re: multinettin

Why not seperate them out on VLANs if you need that granularity?

ex: 10.10.2.1 VLAN3
then just tag VLAN 2 ports 25/26
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.