HPE Community
Switches, Hubs, and Modems
1855505 Members
12971 Online
104111 Solutions
New Discussion

Procurve 1810g-24 Trunking

 
tractor
Occasional Contributor

‎03-16-2011 10:29 AM

‎03-16-2011 10:29 AM

Procurve 1810g-24 Trunking

Hi,
I have two of these switches. I am attempting to trunk 2 cables between the two. I have added the trunks on both switches, and they both show up as active.

I am unable to reach the 2nd switch (the one on the end of the trunk). I can't access the web interface or ping it. Also PC's connected to it are not reachable.

What am I doing wrong?

Thanks in advance.
0 Kudos
2 REPLIES 2
Mohammed Faiz
Honored Contributor

‎03-17-2011 08:05 AM

‎03-17-2011 08:05 AM

Re: Procurve 1810g-24 Trunking

Are you using VLANs at all? And if so, have you tagged them across the trunk?
0 Kudos
tractor
Occasional Contributor

‎03-30-2011 02:33 PM

‎03-30-2011 02:33 PM

Re: Procurve 1810g-24 Trunking

Thanks.
For some reason the reply I made earlier didn't stick.

I finally got the switches to work by resetting one of them to the default settings. I then configured the trunking again and it appears to be working.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.