HPE Community
Switches, Hubs, and Modems
1847821 Members
4574 Online
104021 Solutions
New Discussion

RSTP

 
sammy-2000
Occasional Contributor

‎04-08-2008 09:11 AM

‎04-08-2008 09:11 AM

RSTP

Just wondering if any change at one of the edge switches (Power cycles) will cause all switches (root included) to re-calculate spanning-tree conf, of course, we will have a network outages
0 Kudos
2 REPLIES 2
cenk sasmaztin
Honored Contributor

‎04-09-2008 04:07 AM

‎04-09-2008 04:07 AM

Re: RSTP

hi sammy

please you send all switch sh run print and sh span print commands.
cenk

0 Kudos
Mohieddin Kharnoub
Honored Contributor

‎04-09-2008 08:06 PM

‎04-09-2008 08:06 PM

Re: RSTP

Hi

With RSTP, you shouldn't get network outage to much if there was.

Anyway, just make sure you have configured the Lowest priority on the Root Switch (priority 0) and if you have a backup root switch with priority 1, so that you can make sure that your Spanning tree topology is fine.

Good Luck !!!
Science for Everyone
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.