- Community Home
- >
- Networking
- >
- Legacy
- >
- Switching and Routing
- >
- 3com Office Connect Managed POE Switch- Retrieve I...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2011 05:53 AM
12-12-2011 05:53 AM
3com Office Connect Managed POE Switch- Retrieve IP address
Hi All
I have need of some advice please. I need to configure VLAN's on the above 3com switch but I do not know its IP address. I have a console cable connected to COM1 on my laptop and I wish to use Hyperterminal to get the IP. Can somebody please tell me the correct terminal settings, ie data bits , stop bits, flow control etc. I have it set at 9600bps, 8 data bits, nil parity, 1 stop bit and no flow control, is that correct please.
Many thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-12-2011 11:45 AM
12-12-2011 11:45 AM
Re: 3com Office Connect Managed POE Switch- Retrieve IP address
Hi Julian,
your terminal settings should be 38400bps and the rest should be fine, if it does not work please refer to the chapter "Getting Started with the Command Line Interface" in the manual, ie: http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02965319/c02965319.pdf
Best Regards,
Johannes