3Com S-Switches

[BVasquez]

I have installed Managed Engine from Zoho to monitor 3Com network switches via SNMP.  Zoho believes I am not using the correct OID numbers for the switches and is the reason why the monitoring probe does not return some of the data.  I disagree because I do receive some monitoring data.  Would someone let me know if the below OID’s are correct or not correct for each switch.

3Com S4210 9-Port                 1.3.6.1.4.1.43.1.16.4.3.42

3Com S4210 PWR 9-Port       1.3.6.1.4.1.43.1.16.4.3.78

3Com S4400                             1.3.6.1.4.1.43.10.27.4.1.2.4

3Com S4500G-24                    1.3.6.1.4.1.43.1.16.4.3.30

3Com S4500G-24-PWR         1.3.6.1.4.1.43.1.16.4.3.32

3Com S4500G-48                    1.3.6.1.4.1.43.1.16.4.3.31

3Com S4500G-48-PWR         1.3.6.1.4.1.43.1.16.4.3.33

3Com S4800G 24-Port            1.3.6.1.4.1.43.1.16.4.3.34

3Com S4800G 48-Port            1.3.6.1.4.1.43.1.16.4.3.35

3Com S5500-28-EI                  1.3.6.1.4.1.43.1.16.4.3.13

3Com S5500-28-PWR-EI       1.3.6.1.4.1.43.1.16.4.3.15

3Com S5500-28-SI                  1.3.6.1.4.1.43.1.16.4.3.11

3Com S5500-52-EI                  1.3.6.1.4.1.43.1.16.4.3.14

3Com S5500-52-PWR-EI       1.3.6.1.4.1.43.1.16.4.3.16

3Com S5500-52-SI                  1.3.6.1.4.1.43.1.16.4.3.12

3Com S5500G-24                    1.3.6.1.4.1.43.1.16.4.3.7

3Com SW8807                         1.3.6.1.4.1.43.1.16.4.3.4

3Com Switch 4510G-48         1.3.6.1.4.1.43.1.16.4.3.84

Thanks,

Bob V.