ISP link failover configuraiton between two ISP

[Muthukumar1]

Hi team,

           We have 5945 4 slot switch and need to configured ISP failover configuration betwenn two ISP's . Could you suggest configuraiton document/ sample configuraiton.

same like as IP sla confifuraiton on cisco switch..

Regards

Muthukumar

[Ivan_B]

Hi @Muthukumar1 !

IP SLA in Cisco is analogue to Comware's NQA. You need to configure NQA with a ping (for example) and then associate that NQA to a static route through Track. Seems you know IP SLA so I think you will get the idea about NQA and Track with no issues. Check it here  https://community.hpe.com/t5/comware-based/acl-to-block-inter-vlan-traffic/m-p/7098842 , page 234, " Configuring Track". If you need more information about NQA, check the Network Management and Monitoring Configurtion Guide - https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-a00052908en_us

Hope it helps!

[Muthukumar1]

Hi,

Thanks for your guidence and can i get sample diagram with configuration example?

Thanks

Muthukumar

[Ivan_B]

Did you have time to read the guides I've sent you? I think they have all you need.

[Muthukumar1]

HI,

     I am reading the document and this is new project requirements and proactive i am going through all the documents as customer new requirements. still not applicable the configuration since material will deliver by next week. If any challenging on this surely i will ping you.

Thanks

Muthukumar