Need Help in SNTP

[shinepothen]

Hi Team

I have done configuration for SNTP but it looksl ike my time is not syncing.

Please let me know what are the commands that i need to use

sntp server priority 1 10.10.40.63

(config)# sh sn
snmp-server
snmpv3
sntp
Adyar_SW4(config)# sh sntp

SNTP Configuration and Status

Time Sync Mode : TIMEP

SNTP Mode : DHCP
Poll Interval (sec) : 720
SNTP Authentication : Disabled
Source IP Selection : Outgoing Interface

SNTP Server Address VLAN Active
--------------------------------------- ---- ------

Adyar_SW4(config)#

let me know if you need any more information to help me .

[HappyBiswa]

HI 

few questions .

1.Switch make and model 

2. whole SNTP config

3. Ping to SNTP server 

Thank you 

[shinepothen]

Hi

Please find the below response.

ITS_SW1(config)# sh ver

Image stamp: /ws/swbuildm/rel_venice_qt3_qaoff/code/build/lakes(swbuildm_rel_venice_qt3_qaoff_rel_venice_qt3)
Apr 19 2018 11:22:48
YA.16.05.0008
544
Boot Image: Primary

Boot ROM Version: YA.15.20

ITS_SW1(config)# ping 10.10.40.63
10.10.40.63 is alive, time = 4 ms
ITS_SW1(config)#

timesync sntp
sntp server priority 1 10.10.40.63
time timezone 330

ITS_SW1(config)# show sntp

SNTP Configuration and Status

Time Sync Mode : SNTP

SNTP Mode : DHCP
Poll Interval (sec) : 720
SNTP Authentication : Disabled
Source IP Selection : Outgoing Interface

SNTP Server Address VLAN Active
--------------------------------------- ---- ------

ITS_SW1(config)#