HPE Community
Web and Unmanaged
1751860 Members
5120 Online
108782 Solutions
New Discussion

1810G port speed limit issues

 
Mads Lahrmann
Occasional Contributor

‎05-26-2011 05:36 AM - last edited on ‎12-25-2013 07:34 PM by

‎05-26-2011 05:36 AM - last edited on ‎12-25-2013 07:34 PM by

1810G port speed limit issues

Hey guys.

Im having an issue with the port speed limits of around 10 switches running 1.18 firmware. When I set ports to be limited to 10Mbit they seem to actually run at 1Mbit. Have anyone has any issues with this before?

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. -HP Forum Moderator

0 Kudos
1 REPLY 1
Jay Cardin
Frequent Advisor

‎05-27-2011 03:45 AM

‎05-27-2011 03:45 AM

Re: 1810G port speed limit issues

You likely have a duplex mismatch. Make sure both the switch and the NIC have the same duplex settings.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.