HPE Community
Web and Unmanaged
1752780 Members
6248 Online
108789 Solutions
New Discussion

HP 1910 - unnecessary SNMP Recovery Traps

 
HAL-9000
Occasional Contributor

‎06-03-2014 01:56 AM - last edited on ‎06-08-2014 08:00 PM by

‎06-03-2014 01:56 AM - last edited on ‎06-08-2014 08:00 PM by

HP 1910 - unnecessary SNMP Recovery Traps

Hi,

I'm using two HP 1910-48G Switches. To monitor these switches I use SNMP v2 in my LAN. They both work fine, but sometimes they send out a recovery message. First I thougt they had a problem but they worked fine without interruption. Once I was logged in at the web interface meanwhile they sent two times a recovery trap. But I was was logged in without interruption. The network traffic also is working fine.

 

Does anyone know what could cause these messages and how to disable them? It is a little bit annoying to be notified several times a day that the switches are still working fine.

 

Tank you!

 

 

P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. - Hp Forum Moderator

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.