HPE Community
Web and Unmanaged
1830460 Members
2483 Online
110004 Solutions
New Discussion

HP V1910-16G setting up other VLAN interface cannot PING, only VLAN1 works

 
jkchoa2173
Frequent Visitor

‎03-21-2019 02:25 AM

‎03-21-2019 02:25 AM

HP V1910-16G setting up other VLAN interface cannot PING, only VLAN1 works

Hi,

I got a Hp V1910-16G switch and have updated it firmware to version 5.20_R1519P03.

Am trying to setup VLAN on it as listed below, however after setting the interface IP addresses, the gateway IP of VLAN10, 20  and 1 cannot be PING.  Only on VLAN1 it can see the three gateway IPs.

For example I connect a laptop with IP 192.168.200.11 (gw 192.168.200.253).  It does not work too when I set IP of laptop to 192.168.150.12 (gateway 192.168.150.253)  I was following a vmfocus how tos titled "how to configure layer3 static routes & vlans on hp v1910 24G"  I can't seem to find out what's wrong maybe you can help.

I was assuming after setting the interface IP, routing between VLANs will work naturally.  But in actual the gateways IP are not ping able for VLAN20 & 10

VLAN1 - 192.168.100.253 for pc users

VLAN10 - 192.168.200.253 for IPCameras/CCTV

VLAN20 - 192.168.150.253 test VLAN

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.