Multicast suppression on HP 1910

[shpeka]

Hello. How to limit multicast traffic, output to port?

As I understand, "multicast suppression" options work only for input from port, because now I have next:

[HP V1910 Switch]display interface GigabitEthernet 1/0/4
GigabitEthernet1/0/4 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: b8af-6719-257d
Description: GigabitEthernet1/0/4 Interface
Loopback is not set
Media type is twisted pair, Port hardware type is 1000_BASE_T
100Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 10240
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-pps: 1
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Port priority: 0
Last clearing of counters: 17:09:45 Wed 04/26/2000
Peak value of input: 106649 bytes/sec, at 2000-04-26 19:39:14
Peak value of output: 1806616 bytes/sec, at 2000-04-26 19:40:04
Last 300 seconds input: 114 packets/sec 104810 bytes/sec 1%
Last 300 seconds output: 1379 packets/sec 1799085 bytes/sec 15%
Input (total): 103281 packets, 63253432 bytes
102784 unicasts, 497 broadcasts, 0 multicasts, 0 pauses
Input (normal): 103281 packets, 63253432 bytes
102784 unicasts, 497 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, - throttles
0 CRC, 0 frame, 0 overruns, 0 aborts
- ignored, - parity errors
Output (total): 691238 packets, 806588666 bytes
76991 unicasts, 13672 broadcasts, 600575 multicasts, 0 pauses
Output (normal): 691238 packets, 806588666 bytes
76991 unicasts, 13672 broadcasts, 600575 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
- lost carrier, - no carrier

[HP V1910 Switch]

P.S. This thread has been moved from Switching > Comware-Based to Web and Unmanaged - Hp Forum Moderator