switch - startup-config deleted. How to insert into the machine

[quinho]

good afternoon
The configuration and backup files of my hp 1920-48G switch were deleted and the consequence of this action is that the device does not boot. I downloaded the files on the HP support website and they are saved to the pendrive. How do I copy them to the switch so that the device can boot normally 

[crown_prince]

You can factory reset the switch. it will boot up as new.

Below are steps for 2910al, i hope it works fine for you..

https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c01983060

[quinho]

This is what I can not do, because when I select 5 to restore from the factory default a message appears saying that the password recovery capability is enabled. That I have to disable the password recobery by the CLI command line. However, the switch does not perform BOOT because there is no configuration file to perform BOOT. The message "BOOT failed" appears, so I can not disable password protection and therefore can not restore the factory default