HPE Community
Web and Unmanaged
1831593 Members
3005 Online
110027 Solutions
New Discussion

v1910 inter routing

 
D2G
Visitor

‎11-21-2013 07:55 PM - last edited on ‎11-24-2013 06:19 PM by

‎11-21-2013 07:55 PM - last edited on ‎11-24-2013 06:19 PM by

v1910 inter routing

Hi

 

I got some old HP switches to test and that include a v1910-48G.

 

I created 2 VLANs: VLAN10 and VLAN20. Vlan interfaces are 192.168.10.99 and 192.168.20.99 respectively.

Default VLAN1 is 192.168.2.99

Gateway is 192.168.2.1

 

IP4 routing Table as follow

 

Destination IP Address         Mask       Protocol     Preference    Next Hop    Interface
0.0.0.0                   0.0.0.0            Static            10            192.168.2.1    Vlan-interface1
127.0.0.0      255.0.0.0            Direct            0               127.0.0.1    InLoopBack0
127.0.0.1      255.255.255.255    Direct            0            127.0.0.1    InLoopBack0
192.168.2.0      255.255.255.0            Direct            0            192.168.2.99    Vlan-interface1
192.168.2.99      255.255.255.255    Direct            0            127.0.0.1    InLoopBack0
192.168.10.0      255.255.255.0            Direct            0            192.168.10.99    Vlan-interface10
192.168.10.99      255.255.255.255    Direct            0            127.0.0.1    InLoopBack0.

 

But I cannot ping the hosts at vlan 10 and vlan 20 . IPs are 192.168.2.200 GW 192.168.2.99 and 192.168.10.200 GW 192.168.10.99.

 

Please advice and thanks .

 

D2G

 

P.S. This thread has been moved from LAN Routing to Web and Unmanaged. -HP Forum Moderator

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.