Help with boot from SAn Bl35p

[pardelinha]

Hello.
I am try to configure a BL35p to boot from SAN (MSA100) and i get an error i don't undestand.
" The hard disk containing the partition or free space has a LUN greater than 0. Setup cannot install windows on this disk"
The blade has an Emulex FC. The configuratios is:
- Bios active.
- Boot device configured
- Autoscan disabled
- Topologu P2P
- Othe confs by default

Can anyone help me?
Thanks in advance.
Pedro

[sandeep_raman]

Hello pardelinha,

Hope this has some information,

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00580093/c00580093.pdf

SRH

[Albert Austin]

Did you manage to solve this issue? I have run into the same problem.
Heres a link to my thread.

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1064376

Albert

[Wade Fleet]

Hi guys,

Was this ever resolved as I am trying to solve this issue myself...

anybody have a solution.

Regards

Wade

[dave rowland_2]

try zoning the switch so there is only one path for the build, you can then zone for the other paths AFTER you have installed the MPIO (multipath) driver