Posted to: Integrity Servers
6 hours ago Hello,I have a question. I’m trying to deploy an EAP-TLS certificate for an IP camera using a Windows server (ADCS and NPS) on a 6000 switch, but I keep getting an error message (see photos). Do you have the commands to configure the switch? Posted to: HPE OneView
Friday From the HPE Enclosure, Getting " connection to the enclosure **** could not be made. The primary OA could not be reached. Locked I am trying to remove a server from the enclosure and getting error.
Posted to: HPE 3PAR StoreServ Storage
Tuesday Hello Team,Recently we had a disk failure on 3PAR 8400. The disk with pdid 124 was in failed state and we replaced it with a new diskthe new disk received a pdid of 34 and the service mag process could not be completed and the state as degraded. We a... Posted to: ProLiant Servers (ML,DL,SL)
11-12-2025 Until Gen 11 it was a no-brainer to use a maintenance window and boot the image via iLO, let it run (to have more information, I always used interactive mode) and be happy.Now that someone, for an reason I can't even guess, decided that Gen 12 isn't ... Posted to: ProLiant Servers (ML,DL,SL)
Friday Have a Proliant DL380 Gen10 (ILO 5) with a P408e-p controller. Trying to attach a Promise enclosure loaded with SSD's. When the array is attached I start getting temp warnings/repaired repeating from the ILO. The Promise array is well within it's ... Posted to: MSA Storage
Friday I have a professional CCTV system with a DL380 Gen10 Plus server. This server is back-to-back connected to MSA2060 FC 16GB using a SN1200E 16GB HBA.This year I will replace the current server to a new DL380 Gen11 one, with is not compatible with SN12... Posted to: StoreEver Tape Storage
2 weeks ago After a scheduled power outage the MSL 6480 OCP touchscreen will not respond. The OCP will accept initial touchscreen calibration, but will not accept input after Tape Library initialization.The OCP was replaced with the replacement OCP displaying id... Posted to: Array Setup and Networking
01-01-2021 Good DayWe currently have a Nimble CS220 which is in a boot loop and i am unable to get back online.I have removed both controllers, reseated the ram, powered off and on multiple times to no avail.This has happened in the past, however eventually boo... Posted to: HPE OneView
Friday After upgrade from OneView 10.00 to 11.01 we have noted a persistent alert that Remote Support Unable to Connect to HPE. Additionally when you try to edit remote support settings you get an error unable to connect to HPE. Posted to: HPE Alletra Storage
Friday Good day all,I have an Alletra 6010 Volume that got corrupted due to unexpected power failures. If I present the volume to the Hyper-V (ISCSI) it shows up under the disk manager as (RAW). I cloned a shapshot and presented the clone - without any prob...
