Posted to: ProLiant Servers (ML,DL,SL)
an hour ago Hi everyone, I am hoping someone in the community can help me with a firmware issue on my HPE ProLiant XL170r Gen10 server. The Issue: I am trying to install Intel Optane Persistent Memory modules in this server. However, I am unable to configure th... Posted to: ProLiant Servers (ML,DL,SL)
13 hours ago Hello,I am looking for a COV for ProLiant DL360 Gen 10 and ProLiant DL380 Gen10.
Posted to: HPE Alletra Storage
2 weeks ago HiWhat are the rules behind configuring async replication relationships between new and old Nimbles? I have some data on an old CS300 that I would like to replicate to an Alletra 5k. The old CS300 are running firmware version 5.x and the Alletra 6.x.... Posted to: Software - General
a week ago Dear Team,We are currently running firmware version YB.16.11.0026 on the Aruba J9782A (2530-24) switch. We would like to understand whether any known bugs or limitations have been reported for this specific firmware version, and how such issues could... Posted to: ProLiant Servers (ML,DL,SL)
Saturday I have an HP ProLiant ML310e Gen8 v2 with an issue on FAN1 (rear system fan / CPU zone).Facts:Both fans are original HP fans.Both fans work correctly.Both motherboard fan headers work electrically.If I swap the fans, the behavior follows the header, ... Posted to: ProLiant Servers (ML,DL,SL)
Saturday I have a DL380 GEN10 with a cage that has the 2 nvms and 3 pciex slots and I wanna make sure I did my research that they indeed spent the $$ to have a 2nd nvme slot [labelled 14 on my riser] but actually is not usable? Slot 13, nvme #1 works fine, bu... Posted to: Disk Enclosures
Friday Environment:DL360 Gen8, with P822 installed. One EMC SAE shelf, one HP M6720 shelf, both populated with 24 drives. Each had one array / logical drive defined on it. After trying to configure both for MPIO, upon reboot neither array /. LD was detected... Posted to: ProLiant Servers (ML,DL,SL)
07-17-2025 Had case open with HPE Support for over a month. Have had a repalcement systemboard nad CPU and a new Microserver.Wanted to start this thread.On a new updated Microserver with latest BIOS,iLO & other firmwares I can flash from iLO. I cannot even get ... Posted to: ProLiant Servers (ML,DL,SL)
16 hours ago My Server is ML 30 Gen 11 and current resolution setting is 1680*1050. Refresh rate 85 Hz. and due to this screen is laggy and choppy. is i try to cvhange my screen resolution to Recommended 1920*1080. RGB lights comes up on screen. I am using DP por...
Posted to: MSA Storage
12-16-2025 MSA 2070 예비 디스크 - 동적 예비 디스크 기능을 설정됨으로 변경하고 싶습니다.Storage Management Utility 에서 어떻게 설정하면 되겠습니까?
