HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
Aruba & ProVision-based
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Module not present for port

 
Dhanushkaw
Dhanushkaw
Occasional Visitor

‎08-06-2016 08:04 PM

‎08-06-2016 08:04 PM

Module not present for port

I have new HP 2530 switch and when i type display current configuration

It does not show any physical ports

and 

show interface brief

It shows : Module not present for port

any idea? how i going to configure the physical ports

 

0 Kudos
Reply
2 REPLIES
16again
16again
Respected Contributor

‎08-07-2016 04:32 AM

‎08-07-2016 04:32 AM

Re: Module not present for port

display current-configuration seems like comware command to me, on procurve it's "show run"

Interfaces without any config don't show up in the configuration.  Just add description to a port to see it listed in config.
Module not present might be from missing SFP module.

0 Kudos
Reply
harendra
harendra
Occasional Advisor

‎08-08-2016 02:04 AM

‎08-08-2016 02:04 AM

Re: Module not present for port

better to do factory default again

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.