Connection between ProCurve 2810-24G and ProCurve 2610-24

[lucap]

I have a system with two switches ProCurve J9021A - 2810-24G and other seven peripherals switches ProCurve J9085A - 2610-24.

The peripherals are linked in the MiniGBic ports of the two main switches, but I have no network connection from the center to the peripherals.

Did someone find problems with this type of connection?

I have to say that the firmware on board is not the latest one, I'm going to update it on all of them but I will be granted to know that a new firmware can be the solution (the system is abroad and I'm going to travel there)

Tnx in advance

Luca

[Richard Litchfield_1]

These are traditional ProCurve switches, and should really be in the E-Series section.

Things to check:

• Only ProCurve SFP/optics are supported.
• The SFP ports are dual personality - cannot have a network cable plugged in to the same numbered port.
• Do you have any VLANs? Make sure the ports are in the same VLANs or you have trunking an routing sorted out properly.