HPE Community
HPE EVA Storage
1830150 Members
15003 Online
109999 Solutions
New Discussion

QLA 2462 and SHG80 array controlers

 
Clutier_1
Occasional Advisor

‎11-28-2006 06:10 PM

‎11-28-2006 06:10 PM

QLA 2462 and SHG80 array controlers

Hi,

I've got a problem while trying to connect a server to my HSG80 array controlers with a QLA 2462 HBA :
I can't see any LUN created on the MA8000 disk array, even through the QLA bios utility (accessed with an during the server's boot phase).
The only thing I see is the 2 HSG80 controlers.

Where is the problem ?
0 Kudos
Reply
1 REPLY 1
Steven Clementi
Honored Contributor

‎11-29-2006 02:27 AM

‎11-29-2006 02:27 AM

Re: QLA 2462 and SHG80 array controlers

Are your units access paths defined?

On the controller, run "Show Dx" where x is a unit number you have configured for this server. Post the output here.


What driver version do you have installed?


Steven
Steven Clementi
HP Master ASE, Storage, Servers, and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5, vSphere 6.x)
RHCE
NPP3 (Nutanix Platform Professional)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.