HPE Community
Operating System - HP-UX
1756804 Members
2637 Online
108852 Solutions
New Discussion

Re: ITE Console parameters on HP-UX 11.11

 
Nicolas GIMMILLARO
Occasional Contributor

‎10-27-2009 06:46 AM

‎10-27-2009 06:46 AM

ITE Console parameters on HP-UX 11.11

Hello,

I have a visualize C3750 workstation with HP-UX 11iv1. The system console (when dtlogin is suspended) is in 7bits ASCII mode after each boot. I have to switch to 8 bits mode (numlock/config keys/terminal config/...) to have a working console.

How can I make 8 bits setting the default ?

Thanx
0 Kudos
Reply
1 REPLY 1
Dennis Handly
Acclaimed Contributor

‎10-28-2009 02:30 AM

‎10-28-2009 02:30 AM

Re: ITE Console parameters on HP-UX 11.11

I'm not sure you can. For a HP terminal there was a "save config" button where you could do that but the ITE probably doesn't emulate that.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.