Networking
Find answers to your questions about Networking.
Legacy
cancel
Showing results for 
Search instead for 
Did you mean: 

Hewlett Packard Enterprise Community

Join the conversation with experts and colleagues to get advice, discuss issues, and find solutions
Posted to:
Original author:
I'm having a ton of problems with my HP 6700 printer since installing 10.10.4. My MBA sees the printer but shows it as sleeping. I can use the printer utility and connect to the printer, check the ink levels, etc. but the printer queue says the...
Posted to:
Original author:
I just purchased a few brand new J4858C sfp fiber modules for an aruba 2920-48g switch and installed them in port 47 and 48. When i try to run the command trunk 47,48 trk1 lacp i get the message "module not present for port or invalid port: 47-4...
Posted to:
Original author:
Hi Folks and Folkesses, I have about a dozen of the procurve 2810-24g switches which all seem to have the "bad code in flash" when they post..........they go straight to the rom Promp (=>)...............I have read mostly on the 2910 tha...
Posted to:
Original author:
Hi I’m having problems with HP PCM and SNMP v2 write community for 4 switches the rest work fine but are a different model (2910) Switches I’m having trouble with 2 x 5406-zl on firmware K.16.02.0014 2 x 2920-Switch-Stack firmware WB.16.02.0012 PCM v...
Posted to:
Original author:
HI I've been searching web for a while and still I am not able to find something that makes me sure in our company we want to use HP NC560 sfp+ in a normal pc ( asus maximus viii mobo ), but before we buy that and try, does HP Nic's work outside HP s...
Posted to:
Original author:
PLEASE ADVISE OF THE DIRECT REPLACEMENT PART FOR PART NO. J4859A
Posted to:
Original author:
Hi Robert, In the simplest form, I used to remember a 'Tagged' port as an inter-switch link and an 'Untagged' port as a host port. Basically, its all about the VLAN information that gets 'tagged'into the Ethernet frame. When you configure a port as '...
Posted to:
Original author:
no interface B1 power-over-ethernet ref: 3500-5400-6200-6600-8200-MCG-Sept09-11-PoE.pdf hth...jeff
Posted to:
Original author:
You can also backup the config remotely with SSH and SCP enabled on the switch ("ip ssh" and "ip ssh filetransfer"), using: (for example) pscp -scp -l USERNAME -pw PASSWORD -2 192.168.100.1:cfg/running-config c:\switch.cfg
  • Legend
  • New MessagesNew Messages
  • No New Messages No New Messages
  • Hot TopicHot Topic
  • Replied-to Thread Replied-to Topic
  • Read Only ThreadRead-Only Topic
Events
June 6 - 8, 2017
Las Vegas, Nevada
Discover 2017 Las Vegas
Join us for HPE Discover 2017 in Las Vegas. The event will be held at the Venetian | Palazzo from June 6-8, 2017.
Read more
Each Month in 2017
Online
Software Expert Days - 2017
Join us online to talk directly with our Software experts during online Expert Days. Find information here about past, current, and upcoming Expert Da...
Read more
View all
Top Authors
Advisor
1
Honored Contributor
34
View all