- Community Home
- >
- Networking
- >
- Wireless
- >
- M and MSM Series
- >
- MSM760 guest access
M and MSM Series
1755763
Members
3107
Online
108838
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-22-2013 07:31 AM
11-22-2013 07:31 AM
MSM760 guest access
HI,
I've have an issue, configuring the guest access on the msm760 controller.
connected to the guest vlan, i get an correct ip adres and i'm promped to enter my credentials.
But I cannot connect to the internet.
apparently the wireles lan controller doesnt route the guest vlan to the internet port.
I've tried multiple settings but none of them worked...
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-10-2013 06:58 AM
12-10-2013 06:58 AM
Re: MSM760 guest access
by default, your controller will egress using the routing table (from the online help):
Select the Default option to send traffic without specifying a specific interface. The interface that is used will be selected by the routing table based on the traffic destination. To configure the routing table, select Controller >> Network > IP routes.
If your internet port is configured/connected, then you should egress through that interface.
So first thing, check your routes (Network -> IP Routes)
Select the Default option to send traffic without specifying a specific interface. The interface that is used will be selected by the routing table based on the traffic destination. To configure the routing table, select Controller >> Network > IP routes.
If your internet port is configured/connected, then you should egress through that interface.
So first thing, check your routes (Network -> IP Routes)
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP