MSA Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

FW synchronization algorithm when replacing P2000 MSA G3 controller

 
Highlighted
Occasional Visitor

FW synchronization algorithm when replacing P2000 MSA G3 controller

G4/G5世代のMSAのSMUリファレンスガイドには保守部品のコントローラー交換を実施した場合、元のコントローラーから交換部品へFWが同期されるとの記載があるが、P2000 MSA G3には同様の記載が見つかりませんでした。

G3のMSAも同様のFW同期アルゴリズムが動作するのか確認したい。

Google Translated

The SMU reference guide for the G4 / G5 generation MSA states that if a maintenance part controller is replaced, the FW will be synchronized from the original controller to the replacement part. Could not be located. I want to check if the same FW synchronization algorithm works for G3 MSA.

2 REPLIES 2
Highlighted
Honored Contributor

Re: FW synchronization algorithm when replacing P2000 MSA G3 controller

Hi,

go to the CLI and enter:

show advanced-settings

Look for

Partner Firmware Upgrade

The command is:

set advanced-settings partner-firmware-upgrade enabled|disabled|on|off

Cali

 


======================
That was not planned in this way.
Highlighted
Acclaimed Contributor

Re: FW synchronization algorithm when replacing P2000 MSA G3 controller

For the P2000 (MSA2000 G3) the controller with the newer firmware clones to the controller with the older firmware.

This is different to G4 and G5 (see above).


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!