Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

Can't Add members to Trunk

Defjam
Occasional Visitor

Can't Add members to Trunk

G'Day all.

 

I have an  HP ProCurve 1810G - 24 GE running P.2.12. I am looking to enable LACP for some servers attached to the switch.

 

I can create a Trunk, but when I go to add members there is nothing availbe in the trunk ID drop down, and I have the message "No Trunks Available For Configuration".

 

Screenshots attached of both the Trunk Config and Trunk Membership pages. Config shows the trunk havign been created, but I can't add members.

 

Thanks in advance for any assistance.

 

 

P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. -HP Forum Moderator

1 REPLY
Wah-C
Occasional Visitor

Re: Can't Add members to Trunk

Hello,

 

I faced the same problem today using a HP 1810G-24: Under Trunks - Trunk Membership I just got the message "No Trunks Available For Configuration" and couldn't select the trunk I created before.

 

The solution was, in my case, quite simple: Instead of using Internet Explorer 11, I used Mozilla Firefox and now I could select the trunk I created before.

 

Hope this will help.

 

Kind regards