- Community Home
- >
- Storage
- >
- HPE Nimble Storage
- >
- Array Setup and Networking
- >
- Re: Changed Volume Name on Nimble Not Reflected in...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-20-2014 01:32 PM
тАО08-20-2014 01:32 PM
Afternoon,
I went onto the Nimble and changed a volume name from GoOilers to RSRM3. The name was immediately reflected in the Nimble web interface but not in vCentre. I rebooted 2 of the 4 hosts and did a rescan\refresh of the host Storage and I continue to see GoOilers.
Any advice?
Thanks,
Chris
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-20-2014 07:28 PM
тАО08-20-2014 07:28 PM
SolutionHey Chris, the behavior you experienced is expected. VMFS Datastore names are defined in Vmware, not on the storage subsystem. For example, below I have created a new volume on the Nimble array named "Test". When I scan, the disk shows up with the eui and the path id (Iqn). You can see the name of the volume embedded as part of the IQN.
After adding the disk and selecting VMFS 5, I verify the device and capacity.
When I click next, I am asked to name the Datastore in VMware. Note that the name is not inherited from the eui or path id from the storage subsystem. I must name the datastore in Vmware.
I can also right click on an existing datastore and select "rename". That is the task I believe you want to do if you are looking to rename an existing datastore to match the name on your Nimble.
I hope that helps!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-21-2014 07:29 AM
тАО08-21-2014 07:29 AM
Re: Changed Volume Name on Nimble Not Reflected in vCentre 5.5
Spot on, thanks for the quick reply.