Factory Reset Alletra 6010 Array

[Dassl95]

Hi,

I need to reset my Alletra 6010 Array to factory.  is that possible to do With cli? 

i found the following command 

array --resetup

Thanks a lot for some feedbacks  

Best regards
Dustin

[Sheldon Smith · Accepted solution]

Depends on how "reset" you want it to be. What do you want to accomplish?

array --resetup  will set a standalone array to a state where you can run the setup command again. No data will be lost. Using this command does not revert the array to a fully uninitialized state.

You will need to work with Nimble Support to get it to a fully uninitialized state. Which will delete any and all data.

[sbhat09]

Hello @Dassl95,

Yes. As Sheldon Smith has rightly mentioned, 'resetup' is not a complete factory reset command.

You can refer pg no 12 of this document for more details - https://community.hpe.com/hpeb/attachments/hpeb/array-setup-networking/891/1/pubs_command_reference_2_3.pdf

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of HPE.